Reboot the Digi, and then look for it in RSLinx. The next steps only apply if you need the ML1500 to be able to send messages to other PLCs on the network. Then on page 11 of the guide, follow those directions to choose the right serial port. I might be mistaken, but I think you just need to pick the Message Source Location to "Receive messages from network devices connecting using the network" and pick Allen-Bradley Ethernet TCP 2222 Press Help if you need more explanation." I don't think you have a serial HMI connected to the 2nd Digi serial port, do you? If not, then the next page can lead you down the wrong path. Click Next and set the appropriate value in the following screens. On the bottom of page 7 of the guide note that it says: "Our HMI is on serial port 1. It is starting to get a little frustrating.Īll I remember doing was selecting the Industrial protocols radio button and then the Rockwell/PCCC Family radio button. The worst part is, I have just started at a new company, and have been working at setting this up for 3 days now. I am not sure if the IAP is to be set up as the master or slave?Īnd is the destination the PLC or the computer running the HMI software? I changed the setup to 19.2k and still no luck. That is the manual I am using to set it up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |